In English

Simulation of the Flow around a Semi-Submersible using CFD

Jonathan Eriksson
Göteborg : Chalmers tekniska högskola, 2017. 65 s. Report. X - Department of Shipping and Marine Technology, Chalmers University of Technology, Göteborg, Sweden, 2017.
[Examensarbete på avancerad nivå]

The application of Computational Fluid Dynamics (CFD) is almost taken for granted within sectors of engineering dealing with fluid flows. However, its usage within the offshore sector is still limited, primarily due to the large computational times necessary for solving complete sea states. But with increasing computational power and creative new solution methods emerging, the threshold of usability is continuously being lowered. Today the industry relies heavily on scaled model tests; tests which are expensive, time consuming, and may face discrepancies due to scaling effects and unreliable measuring equipment. By utilizing CFD instead, one can analyze the physical properties anywhere within the computational domain, as well as customize and adjust the geometrical and numerical settings at any time. The main objective of this thesis is to investigate the use of CFD simulations for the design of semi-submersible offshore structures. In this study the submerged section of an offshore structure is the subject of examination. Data available from a previously conducted wind tunnel experiment are used as means of both verification and calibration of the CFD model. Two different CFD software are used in this work; the open-source software OpenFOAM, as well as the commercial software Fluent. Initially a replica of the wind tunnel is modelled and incompressible steady-state Reynolds Averaged Navier-Stokes (RANS) simulations are performed, as it is of interest to find possible instances where steady-state simulations are feasible. Investigations include full geometry and truncated nearfield steady-state simulations. Non-satisfactory results were obtained. The drag force measured in the steady-state simulations reached only a value of 60% of the experimentally measured one. Unsteady simulations, both RANS and LES showed similar results. Reasons for the unsatisfactory results could be insufficient mesh resolution, along with wrong choice of discretization methods and turbulence model.

Nyckelord: CFD, OpenFOAM, Fluent, semi-submersible, wind tunnel, current loads



Publikationen registrerades 2017-03-29. Den ändrades senast 2017-03-29

CPL ID: 248703

Detta är en tjänst från Chalmers bibliotek